Apparatus For Mechanical Strength Test On Resilient Covers Fig2
BS1363
Technical Parameters:
| Applied force | 230-240N |
Metal test pressure block | R angle of 2.0 to 2.5, width of 25.0 to 25.2 |
| Hardwood block | According to BS1363.1-2018 in Figure 2b |
Product Introduction:
The device conforms to the BS1363-1:2018 clause 9, figure 2.
Resilient accessible external surfaces of socket-outlets shall be
so designed and constructed that when assembled and wired as in
normal use, there is no risk that, as a result of undue pressure,
live parts could penetrate the accessible external surfaces or
become so disposed as to reduce creepage and clearances below those
given in clause 8.
The design of the apparatus shall be such that a steady force of
230-240N can be applied to those places where the possibility of a
failure exists, the force being applied through a metal test
pressure block.
Each sample shall be subjected to the force at each chosen place in
turn. During each application of force, a test voltage of 2 000 V
±60 V 50 Hz of substantially sinusoidal waveform is applied for
60-65s between all live parts bonded together and the metal test
pressure block.
During the test no flashover or breakdown shall occur. Plug Socket
Tester
After the test it shall not be possible to touch live parts with
test 11 of BS EN 61032:1998 applied with a force of 28-30N.
For more details, Please refer to the relevant standard.
9 Accessibility of live parts
9.1 Live parts of plugs shall not be accessible when the plugs are
wired as in normal use and in full
engagement in a corresponding socket-outlet.
9.1.1 Compliance shall be checked by the application of test probe
12 of BS EN 61032:1998 applied with a
force of N with rewirable plugs fitted with a 2-core flexible cord
as given in Table 24 of BS 6500:2000
and non-rewirable plugs as supplied.
9.2 Plugs shall be designed and constructed so as to protect the
user against accidental contact with live
parts during insertion or withdrawal of plugs.
9.2.1 Compliance shall be proved by satisfying the dimensional and
gauging requirements of this
Part of BS 1363.
9.3 Resilient covers of plugs shall be so designed and constructed
that when assembled and wired as in
normal use, there is no risk that, as a result of undue pressure,
live parts could penetrate the cover or
become so disposed as to reduce creepage distances and clearances
below those given in Clause 8.
9.3.1 Compliance shall be checked by the following test (an example
of a suitable apparatus is shown
in Figure 2).
The design of the apparatus shall be such that a steady force of
240 N can be applied to those places
where the possibility of a failure exists, the force being applied
through a metal test pressure block as
shown in Figure 2.
Each sample shall be subjected to the force at each chosen place in
turn. During each application of force,
a test voltage of 2 000 V ± 60 V 50 Hz of substantially sinusoidal
waveform is applied for s between all
live parts bonded together and the earthed test pressure block.
During the test no flashover or breakdown shall occur.
After the test it shall not be possible to touch live parts with
test 11 of BS EN 61032:1998 applied with a
force of N.
9.4 Where a plug is supplied fitted with a flexible cord, the free
end of such an assembly shall be
encapsulated in insulating material.
NOTE This does not apply to assemblies supplied to equipment
manufacturers for incorporation into their equipment.
9.4.1 Compliance shall be checked by inspection.
